Direct current used in the plating process is one of the most important factors affecting the result. Other elements of the coating will take place in the bathroom conditions and surface preparation for the part. The desired result but the process will be available with the appropriate charger. The emerging results of the studies, confirms this.

Preparation of the surface of the track was completed, provided the appropriate density and temperature in a bathroom, good results are expected to be normal when subjected to coating process. Parts that do not require a smooth surface, this is true.The surface smoothness and uniformity of the coating is a process required to be able to show to get exactly the Desired result will shout. The reason for this is that the rectifier DC current in full. In this case, nail polish, etc.. will be added to the bathroom. shout chemicals will be the solution, not only increases costs.

Traditionally used to obtain direct current rectifier system, the network obtained from the three-phase 6 phase 300Hz frequency adjustment as a result of a direct current is generated. It is also called 6Pulse system.Corrected in the bathroom, but the current applied, obtained from a source such as battery current is not as smooth. The average flow is hard Together, the resulting roughness (ripple) are adversely affected due to the process.

600Hz in the system and each phase shift correction is made in two parts with 6Pulse. Each section is another area to fill an output current ripple is provided. The result obtained from approximately 1% ripple current from the battery is almost as smooth as a signal factor. Such a device will be unique in the coating.

600Hz high accuracy of the output current is only provided in the system. Saving energy is also taken from the network when this occurs. Reactive power consumption of conventional rectifier power factor is lower than emerging enterprises, in this case, the compensation and so on. additional costs arise.MRS applied technology of the device with power factor 0.97 - 98 (Bad 0 --- --- 1 Best Medium 0.5) has values​​. Thus, the device is extremely low reagent consumption. The following equipment is nominal output voltage output current graphics.Rectifier output signal 300Hz Ripple 4.15%
      Rectifier output signal 300Hz Ripple 4.15%               Rectifier output signal 600Hz Ripple 1.02%

600Hz output current than the system is linear, as shown in the chart. However, one should not forget the best rectifiers output current values ​​to be operated close to rated voltage. This point should be considered in the selection of rectifier, 10V DC 15V or 20V voltage is sufficient device should not be taken for a bath.

MRS according to the principle of unlimited customer satisfaction with a technology pioneered by other Pulse - Base program also applies 600Hz devices. Simulants in the market, but 300Hz Pulse - Base system finding new ground by throwing a 600Hz pulse MRS sector - has developed a base system.

With the new 600Hz technology with the quality of the applied coating Pulse - Base system brought together the excellent results and shout all kinds of quality control tests to ensure you get the full service is presented.

Before a new device, please ask. Is the suggested  device has output 600Hz 12Pulse?

Application areas;

• Automotive Parts
• Towel Radiators
• Machine Parts
• Taps, Battery and so on. parts
• Mold Surface Treatment
• White Goods Parts
• Chrome, Hard Chrome, Nickel Processes